Hmm, check the translator for the stop sequence. I’m not at my computer right now but if I remember gc should be set to negative 1 and ga to 0. You can set it either at the end of the stop rules or at the beginning of the start rules.
The translator that sets the lights looks at gc and calculates which light to set from there. I set it to -1 so that when the timer starts it starts at 0. The timer increments by one at the beginning of each iteration.
If you get stuck, chime in again and I will help. The objective of this board is not just to do it for you but to help you understand how it is done yourself to make you more self sufficient. It you want a complete solution, I’m available for contract to do work for you. Just email me if you want me to help with a complete solution.
This board is primarily to help new users get over the learning curve or to get them unstuck when they run into an issue.
Steve Caldwell
Bome Q&A Moderator and
Indepedent Bome Programmings Consultant/Specialist
bome@sniz.biz