Awesome, thank you so much.
The unit still ‘fails’ on boot up if I enable it, but if I keep it disabled, it is still detected by both MTP and FLS. I dunno. I will keep trying to set it up and use it as ‘disabled’ in FLS. I assume FLS is reading it through Bome’s port 25 enabled input. That is fine. Either way, you corrected the project setup; I’m grateful, thank you.
If I make a translator for a parameter, it still doesn’t swallow the original signal, so FLS is still receiving notes and playing an instrument because of it. I really don’t know what to do about that at this point. Is there a rule formula I can put in all translators that says to numb the device’s MIDI input after the translator processes, before it goes out of MTP?
…
I discovered that these mysterious ACBD buttons only change the MIDI output of the deck sections, leaving all the mixer knobs only the one bank (This is why I couldn’t figure out their use before). This isn’t that useful; the mixer has most of the parameters. Think that I won’t be utilizing that.
It got glitchy too. When enabling the dj controller, the Launch Control user bank 1 lights went dark. All banks still worked fine, just lights glitched out. Then disabling the dj controller, the bank 1 lights reenabled as a factory preset, not my configured preset lights. Strange. I think that had something to do with me testing out these ACBD bank buttons. It also broke the platter translators. They were working, and then they suddenly weren’t. It was back to the note output when moving them. Very strange.
The platter slow down formula works great. Thank you. I made it a little slower by changing it to uu=6, instead of 4. Think that was the way to do it.
…
You’ve discovered the hassle of the iCue preset when trying to type. Ya it’s annoying. That’s what the ‘suspend MTP’ was about. If I could find some other way of communication from iCue to MTP, I wouldn’t use any keystrokes. But that’s what I have to work with.
…
Sorry to be such a pain. I’m almost there. If I can just get the notes to not end up sending to FLS, having my MTP translators sending to FLS instead, I’ll be all set I think. 