Hi,
The following should work. Key translators are 1.0 and 1.1.
Translator 1.0 will take pitch bend on any MIDI CH and turn it to CC1 on MIDI CH 1 for output.
Translator 1.1 will suppress fader touch/release messages but let all other note messages through.
faderport-fader-to CC1.bmtp (1.9 KB)
Steve Caldwell
Bome Customer Care
Thank you for your Script. When i try to open it. I got these Error Messages:
IN 0.2 Incoming Action corrupt or not supported: Prfm
OUT 0.1 Outgoing Action corrupt or not supported: Prfm
OUT 0.0 Outgoing Action corrupt or not supported: Prfm
You need to install version 1.9.0 or later of Bome MIDI Translator Pro.
Steve Caldwell
Bome Customer Care
I routed it like this
midi input: FaderPort
midi output: Bome MIDI Translator 1 Virtual Out
Is that correct?
After I installed the latest Version of Bome. The Error Messages are gone.
Sadly I couldn’t get it working.
When I move the fader the Event Monitor doesn’t show me anything. Except for button presses. When I press pause play for instance.
Thanks for your help
Yes, make sure also that you have input on your Cubase set to look at “BMT 1”.
If you want to see what MIDI is going it, it is better to use the log rather than the MIDI monitor. Then check Incoming, Outgoing, MIDI IN and MIDI OUT.
Then move your fader and capture what you see.
Then copy and paste what you see so we can figure out what is going on.
If you don’t see any incoming message that means that perhaps Cubase is holding your FaderPort MIDI port open so make sure it is de-selected for input in Cubase and select “BMT 1” instead.
Steve Caldwell
Bome Customer Care
