Hi,
What you are asking is beyond the scope of support here but if you send me an email, I can provide you a cost estimate for creating this for you.
In the meantime, I put together and example of using select buttons to switch layers on the 8 knobs.
First the project puts you into Mode 1
Then it disables all layers and the re-enables layer 1.
The select buttons along the bottom allow you to switch to layers 1 or 2 ( I only set up for 2 layers for this example). These are handled in the preset called "Channel Selector"
Each layer has its own preset and updates the knob positions and LED positions as it is enabled.
The button LED's are also updated within the Channel Selector preset.
I did this on a MK2 but the MK1 has the same knob and button values for the ones you asked about.
I had thranslator enabled for MK2 Init but disabled it and enabled MK1 Init for your. Only one of these should be enabled depending on your model.
Also, I set default MIDI through paths to and from your Application for anything that doesn't have a translator.
You will need to set up the aliases for the application's virtual port and your APC40. You will be prompted when you open the file. After that, if you want to change Aliases you can do that in the MIDI menu of MT Pro.
The global variables used are documented in the rules of the Init Preset, translator "Initializ Globals".
Steve Caldwell
Bome Q and A Moderator and
Independent Bome Consultant/Specialist
bome@sniz.biz
Attachments:
1584034312605_APC-40-Knobs-2020-03-12.bmtp