APC Mini LED Feedback. Hilfe!

Yes, it should work.

You should copy and paste the entire APC MINI Light control preset to your project. Also copy the entire Init preset over and then within the Set Global Variables translators, you can delete anything other than the lines that initialize up to variable gc . (which are the ones I used for MIDIBuddy). In this project I use global variables g1-g6 to manipulate the LEDs so make sure you are not using them anywhere else in your project.

Make sure in the APC Mini Light control preset you have APC MINI as both input device and the only output device defined at the preset level.

Under this scenario, if you change anything with Dot2, the LED’s will be out of sync with your APC MINI so be sure only to change things on the APC-MINI.

If you also want to control the LED’s with Dot2, we will need to see what messages it sends back to the APC Mini. If it sends back good data, (note on for LED on and note off for LED on), then the LED feedback would not be necessary and we just need to put in translators with rules for Dot2 to control the LED’s. If this is the case, we would not need to track global variable state of the LED’s in MT Pro.

If you struggle with all of this and need me to do it for you, please reach out to me via email and I can do this for a fee.

Steve Caldwell
Bome Q and A Moderator and
Independent Bome Consultant/Specialist
bome@sniz.biz