Hi, perhaps you have selected the wrong scene. On my controller in assignable mode, Scene 2 are the faders for MIDI CH2.
You can tell if a translator triggers by doing this.
Check MIDI IN and Incoming in the Log window. If you just see MIDI in, then you have no translators that match the incoming MIDI message. If you have both, you will see which translator is used for that incoming message.
You and also compare MIDI OUT and. If all you have is MIDI out, then it is coming through the MIDI thru routing path. If you have both, then the message is being processed by a translator and you will see which one is processing it.
Another thing to look into is that the Korg MIDI drivers misbehave and sometime re-install themselves. It turns out if you have more than 10 MIDI devices (virtual or real) then your device may not show up at all. See this post on the nanoKontrol2 which also applies to any other Korg MIDI drivers.
In the attached file, All I did was create an alias for dot2 and then set up the thru path to go to that alias.
korgNano–sjc.bmtp (14.7 KB)
Steve Caldwell
Bome Customer Care
Also available for paid consulting services: bome@sniz.biz